![]() Finally, set “Ralink rt2500 (USB) support” to M (module): CONFIG_RT2500USB. Then, enable “Ralink driver support”: CONFIG_RT2X00. In your case, you have to enable “Ralink devices” under Device Drivers/Network device support/Wireless LAN: CONFIG_WLAN_VENDOR_RALINK. ![]() Make xconfig # or make menuconfig if you prefer This will configure and build the kernel once (this can take 15 minutes or so).Īfterwards, enable your desired module: cd linux ko file to /lib/modules, for example, and load it with insmod.įor convenience, you can do the following (on MNT Reform): git clone To build the kernel and module, you have to clone the MNT Reform kernel sources, activate the module you need in the. Also, the kernel itself needs to be rebuilt for Ralink devices support. So you need to build a module for this chip and load the module after your system has booted. The problem with chips like this is that they use firmware blobs that have to be loaded from disk. For example I use Laird EFD2455A3S-10MHF1.Īnyway, I’ve tried to describe how to build a custom kernel and the desired modules: But you can get better reception with a better antenna. Are you sure the WLE200NX won’t do the job for you? It should be very stable.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |